·The Ministry of Industry and Information Technology "Recycling and Dismantling Specifications for Vehicle Power Batteries" was officially implemented in December 2017

According to reports, the "Code for the Recycling of Vehicle Power Battery Recycling" will be officially implemented from December 1, 2017. This is the first national standard for the recycling of power batteries proposed by the Ministry of Industry and Information Technology, clearly indicating the recycling and dismantling enterprises. It should have relevant qualifications to further ensure the safety, environmental protection and efficient recycling of power batteries.
From February 1st, 2018, the new national standard for three power batteries, such as the “Recovery of Residual Energy for Vehicle Power Battery”, will also be officially implemented. With the establishment of a relatively complete national standard system, the disordered state of power battery recycling and ladder utilization is expected to change.
The industry believes that domestic power batteries will enter the peak of scrapping around 2020, with a total scrapped amount of 120,000-17,000 tons, and the actual dismantling and recycling in 2016 is less than 10,000 tons. Due to improper treatment of the positive electrode material and electrolyte in the power battery, the environment is greatly polluted. At the same time, China must use recycling to alleviate the serious external dependence on scarce metals such as cobalt. Therefore, power battery recycling will become the key to the development of new energy vehicles in China, and policy support is expected to increase.

Refrigerant Dryer is widely used in nitrogen/Oxygen Generator, it is a very important part to get rid of water. Its principle is compressed air is cooled in an air-to-refrigerant heat exchanger, then the condensed moisture is separated and drained off. The air is then reheated in an air-to-air heat exchanger with the help of incoming air. This action also pre-cooling the incoming air.

For the cooling method of dryer, there are two types: air cooling and water cooling. For small flow rate machine, normally it is recommended to use air cooling dryer. For big flow rate machines, better use water cooling type.

Refrigerant Dryer Specification

Inlet temperature:≤80℃

cooling method:Air-cooling
Inletpressure:0.4~1.0Mpa
Pressure drop:≤0.03Mpa
Dew point:3~10℃

Refrigerant Dryer

Refrigerant Dryer,Refrigerant Air Dryer,True Refrigerant Air Dryers,Refrigerant Compressed Air Dryer

Shandong Gamma Gas Engineering Co. Ltd. , https://www.gammagas.com