How to reduce the fuel consumption of Ito diesel generator?

The diesel engine diesel engine's compression system wears badly, the piston assembly is wrong, the joints at the joints of the engine are damaged, and the side wall of the oil shell is damaged. This is the cause of excessive oil consumption.
1. When the generator oil consumption is too high, first check whether the body and the gear room cover, the side of the wheel, the rear cover, cover and other joints are leaking. If oil leaks, it should be observed that the gaskets at each joint are intact, and the damaged gaskets must be replaced. If the seal is complete, check the looseness of the connecting screws at each location. Use a wrench to loosen the bolt to the specified torque. If the above parts are normal and the oil leakage is at the rack position, check the oil casing. The main inspection location is on the front side of the oil tank side on the same side as the traveling wheel. Loose screws on the base are used to pull the wheel in the V-belt. A long-term collision with the angle iron on the frame of the protection oil shell is caused, and the oil shell is worn out to form a gap and generate oil leakage.
Second, the normal wear and tear caused by the long-term use of the engine, or the abnormal wear caused by improper maintenance, will cause the cylinder liner of the diesel engine to form a longitudinal pull, and the bore and piston side clearance exceeds the specified value, so that the support force of the piston ring is reduced accordingly. Small, there is no net phenomenon. Or because the inner ring in the oil ring is distorted, the spring is disconnected from the opening position of the oil ring, so that the oil is not clean and participates in the combustion, causing serious oil consumption symptoms. It is difficult to start the diesel engine, and the exhaust pipe has obvious blue smoke emission. Severe respirator injection. In addition, the piston should be on the upward side. When the assembly is reversed due to the direction of the direction of the combustion chamber to form an inverted state, although it will not affect the start of the diesel engine, but the loss of oil will be quite serious, the daily fuel consumption is about 0.5 kg.
Third, the serious wear of the valve guide tube will burn the oil of the diesel generator set . Although rare, according to the introduction of the relevant information, it is also a reason that cannot be ignored.

In this series, Ganland offers a wide selection of high quality and durability standard 304 stainless steel door lock kits. Nowadays, the price competition makes many suppliers using the 201 stainless steel and other bad stainless steel instead of 304 grade. While they just cheating that they are using the grade 304. Here in Ganland, we never ever do such behavior! For the types, we have bar handle locks, cam action door locks, delta handle locks and rear door locking gear with security keys. For the handle types, we have normal stamping bar handle, forged handle, delta handle and box handle with keys. For the sizes, we have the locks suiting for pipe 22mm, 27mm and 34mm. All our cams and keepers are forged making.


stainless steel Door Locks

304 Stainless Steel Door Locks

304 Stainless Steel Door Locks,Roaster Door Handle Lock,Embedded Type Refrigerator Door Lock,Standard 304 Stainless Steel Truck Lock

Jiaxing Ganland Auto Parts Co., Ltd. , https://www.ganlandparts.com

This entry was posted in on