Knowledge of daily maintenance of powder material vehicles:
1. Powder material vehicle chassis: According to the instruction manual of the selected car chassis.
2. Air compressor: According to the specification of the air compressor.
3, power take-off: often pay attention to regular inspection of its lubrication conditions, operating conditions, if any abnormal noise should be identified and promptly ruled out its cause, should check once a year gear bite and wear, can not be over-speed operation.
4. Air circuit: The sealing condition should be checked frequently. If any air leakage occurs, remove it in time. Regularly check the working condition of each valve. If it fails, it should be repaired or replaced. The safety valve must be opened when the pressure is 0.2Mpa, and the pressure in the tank must not be increased. More than 0.2Mpa.
5. Tank: Regularly check the tank weld for air leakage. If this phenomenon is found, repair welding should be performed in time.
6, tank air chamber: often check the air chamber canvas, if moisture is not airtight or damaged, it should be replaced; check the air chamber pressure layer is compacted, if leakage phenomenon, will affect the discharge effect, should be promptly excluded.
Here are some precautions for daily operation steps of some common powder materials vehicles
1. Before each time the material inlet is opened, the pressure relief valve and air inlet ball valve must be opened to eliminate the excess air in the tank to avoid injury.
2, always pay attention to whether the pressure gauge is working properly, and prevent pressure gauges from malfunctioning and overpressure generating tanks.
3, often check the safety valve, to ensure pressure relief at 0.2Mpa, the tank body pressure shall not exceed 0.2Mpa.
4, often check the operation table is working properly, so as not to overrun and damage the air compressor and power take-off box.
5, always listen to the power box and air compressor rotation sound, if there is abnormal sound, should immediately stop troubleshooting.
Hubei Cheng Li Special Purpose Vehicle Co., Ltd., Sales Manager Chen Xin, Tel: Website: Welcome to visit us!
In painting cubicles of e.g. the automotive industry, so-called overspray arises during the painting process. Overspray is made up of the paint which does not adhere to the workpiece and leaks out into the environment as a spray. The air contaminated with these paint droplets is routed via ventilation systems to cleaning units, such as water spray separators. These exhaust air systems frequently have a large surface area and are covered with grates set in the ground of the painting cubicles. A large percentage of this overspray collects on these grates, and in the ducts leading from them. These system have to be cleaned frequently and, in case of extensive use, even daily.
PINFL plunger pumps and complete high-pressure cleaning systems are used, with which the paint residues are removed reliably: The cleaning specialist employs high-pressure guns from Botuolini factory . These are operated with pressures between 600 and 700 bar. The advantage: The botuo high-pressure gun can be guided exactly so that shafts can also be cleaned accurately. Furthermore, our high-pressure guns offer an ergonomic structuring which enables safe and fatigue-free work.
Ultrahigh Pressure Cleaning Machine
ultrahigh pressure cleaning machine,ultrahigh pressure cleaner,600bar cleaning machine
ZHEJIANG BOTUOLINI MECHANICAL CO.,LTD , http://www.botuopump.com