Angle cut-off overview valve

Angle type valve opening and closing pieces are plug-shaped flap, the sealing surface was flat or tapered surface, the valve flap along the fluid center line for linear motion. Stem movement form, lifting rod (stem lift, hand wheel does not lift), there are lifting rotary rod (hand wheel with the stem rotating together, the nut is located in the valve body). Bellows globe valve only applies to fully open and fully closed, does not allow for regulation and throttling. More keyword search: Globe valve

Tube Sheet

Tube sheet are usually made of a round flat plate with holes drilled into the plate to accommodate tubes in the exact location and pattern relative to each other. The tube sheet is used to support and isolate the tubes in the Shell And Tube Heat Exchanger.

A tube sheet is a plate used to support a tube in a shell and tube heat exchanger. The tubes are aligned in a parallel manner and are supported and held in place by the tube plate. A tube sheet is a round plate with holes in it so that the tube can fit through the opening. Tubes are usually made of round, flat metal sheets. Drill holes for pipe ends in precise locations and patterns relative to each other. The tube plate is made of the same range of materials as the pipe.

These are usually made of mild steel and vary in thickness according to fluid pressure. Depending on the final application (petrochemical, nuclear, oil and gas, etc.), the tubes can be clad in stainless steel or other superalloys, or even made entirely of stainless steel or superalloys.

Tube Sheet,Boiler Tube Sheet,Floating Tubesheet,Exchanger Tube Sheet

Guangdong Jiema Energy Saving Technology Co.,Ltd , https://www.heatexchangerjm.com