According to the requirements of the “Quality Projectâ€, Zhengzhou Textile Machinery organized 4 people from the Technology Development Center, Quality Department, Sizing Department and Other units to go to Shandong Dezhou Demian Co., Ltd. and Zibo Yufang Textile Co., Ltd. The GA308 sizing machine that was installed and commissioned in the previous stage was tested for product reliability.
According to the working procedure, after the test personnel arrived at the second unit, they had a discussion with the operation, process, mechanical and electrical maintenance personnel and management personnel of the factory, and listened carefully to the whole unit of the GA308 sizing machine since the installation and operation. In the evaluation, the two factories expressed their satisfaction with the overall sizing machine produced by the company. At the same time, they also exchanged questions on the problems occurred during the production and operation of the sizing machine, and put forward some reasonable suggestions.
The company's test personnel carried out on-site inspection of some important mechanical parameters of the slashing machine with the instrument and made a record. At the same time, the reliability test needs to be recorded in the factory for three months, and the contents of the record are compared. Fine, more data, longer time, need to use the factory according to shifts, sizing varieties, speed, warp length and other items to record the time and content of the failure, to provide a strong basis for the final reliability evaluation. Therefore, the company's sizing design room is specially equipped with technicians to carry out coordination and patrol service in the factory, and work together to do this work.
According to the working procedure, after the test personnel arrived at the second unit, they had a discussion with the operation, process, mechanical and electrical maintenance personnel and management personnel of the factory, and listened carefully to the whole unit of the GA308 sizing machine since the installation and operation. In the evaluation, the two factories expressed their satisfaction with the overall sizing machine produced by the company. At the same time, they also exchanged questions on the problems occurred during the production and operation of the sizing machine, and put forward some reasonable suggestions.
The company's test personnel carried out on-site inspection of some important mechanical parameters of the slashing machine with the instrument and made a record. At the same time, the reliability test needs to be recorded in the factory for three months, and the contents of the record are compared. Fine, more data, longer time, need to use the factory according to shifts, sizing varieties, speed, warp length and other items to record the time and content of the failure, to provide a strong basis for the final reliability evaluation. Therefore, the company's sizing design room is specially equipped with technicians to carry out coordination and patrol service in the factory, and work together to do this work.
Guanxian YX Bearing Co., Ltd. , http://www.sdbearings.com