Cockpit water intake should be cleared in time
After the rainy weather, people's mood will be better, but the performance of aerial vehicles may not be fully restored with the departure of the haze. Sometimes, heavy rain will also leave a lot of sequelae for high-altitude vehicles. The car manufacturer reminds the owners that after the rain, they should carefully check the car.
Inspection items: engine compartment and cockpit
Problem: Water spills into the cabin
Rainwater can run through the hood into the engine compartment through the seams of the engine cover. Under normal conditions, the water will naturally drain away. However, sometimes leaves, dust and catkins will block the drainage holes, resulting in higher and higher water levels in the drainage system. At this time, water will leak into the cabin through the air intake.
Therefore, after the rain, it is necessary to look at the position of the air intake hole in the separation part of the engine compartment and the cockpit of the aerial work platform and whether or not there is water accumulation in the grooves on both sides of the left and right fenders. If there is any accumulated water, you can take the clean water to flush the air intake. Hole, dredge the waterway, if still can not be solved, you need to clean the drainage system at the service station.
Inspection item: air filter
Problem: Odor in the car
During the rainy season, the humidity is high, and some moisture will accumulate in the aerial vehicles. The hot air will cause mildew and odor in the air intake. Therefore, the air filter should be washed out to remove moisture and remove debris. There is an easy way to open the air conditioner's warm air to the maximum, and use a variety of outlet modes in turn, blowing about 15 minutes. At the time of air conditioning work, the outlet temperature can reach 40-50 degrees Celsius, so you can put the tide inside Hot air evaporates and removes mildew.
Inspection item: Braking system
Problem: Abnormal brake sound
For disc brakes, brake discs tend to rust in the rain, causing abnormal brake sound. At this time, the owner of the aerial vehicle can start the vehicle, step on several brakes, and then stop. Whether the rust on the moving plate has been ground or not, if it has been cleaned, you can drive safely. If it is not ground, you can go to the service station for processing. However, this problem does not generally cause security risks.
Sometimes there will be a situation where the lift truck feels astringent after starting and produces a feeling similar to that of the hand brake. This is because the brake shoe is sticking to the brake disc. Don't worry too much. Foot throttle, and then open for a while, you can hear a "click" sound, brake shoe and brake disc will be separated, then you can normal driving.
Inspection item: headlight
Question: The headlights are fogging
The dust cover of high-altitude vehicles and the water entering the vehicle can easily cause rainwater to enter the lights. Water mist forms in the lampshade. The brightness of the lights will be affected when the lights enter the water. Corrosion of the circuit plugs may also cause the lights to erode. damage.
After discovering the headlights entering the water, you can open the dust cover of the headlights and turn on the headlights. After 10 minutes of lighting the headlights, the mist in the headlights begins to disappear. After 1 hour, it can completely disappear. If it disappears, you do not need to worry. However, if there is water fog, we must go to a professional service station for processing.
Inspection item: Hand brake cable
Problem: Damage to the skin of the hand brake cable
If the skin of the brake cable of the aerial workman is broken, it will cause the water to enter the cable, and the cable will be rusted. Therefore, if it is only slightly damaged, you can wrap the waterproof tape. If the damage is serious, you need to change the cable. .
Inspection item: Body paint
Problem: Decrease in vehicle surface gloss
Because the rainwater contains impurities and acidic substances, after the high-altitude operation vehicle is wetted by rain, if the rain is not wiped off in time and then exposed to strong sunlight, the surface is prone to speckle and luster drop. Therefore, it is best to go after rain. The exterior of the aerial vehicle is cleaned.
In addition, exhaust gas, dust, noise, and moisture will seep into the car body from the small hole in the chassis, causing the car body to rust and peel off, and the rubber in the protective layer will also age. Therefore, the chassis of the high-altitude truck should also be washed with clean water in time.
Plain Trolley introduction
GCT Plain Trolley is a kind of lifting device and it has its own characteristics of simple structure and easy operation. It can be attached to chain hoist of Electric Hoist or any other loading machinery to form a loading trolley. It can be easily running on the botton flange of I beam track at a curve radius for loading and unloading goods and equipments.
By different way of driving , the trolley series can be divided into two types: Geared trolley(GCL) and Plain trolley(GCT). The plain trolley is operated by pushing the load and for the geared trolley, we can pull the hand chain to drive it.
Advantages:
1.Plain trolley series is a kind of lifting device and it has own characteristics of simple structure and easy operation.
2.it can be attached to Chain Hoist or Electric Hoist or any other loading machinery to form a loading trolley.
3.It can be easily running on the bottom flange of beam track at a curve radius for loading and unloading goods and equipment.
4.By different way of driving . the trolley series can be divided into two types: Geared Trolley(GCA)and plain Trolley(GCA) the plain trolley is operated by pushing the load and for the geared trolley. We can pull the hand chain to drive it
Specifications:
Products show
Additional features and benefits include:
1.Rugged steel side plates formed to include bumpers and trolley guards
2.Frames connected by steel equalizer pin, secured by two nuts on each side
3.Universal tread flanged track wheels equipped with shielded ball bearings
4.Easy rolling on international standard shapes, wide flange shapes or patented rail
5.Hardened wheels and axles for added strength and durability
6.Spacer washers can be shifted inside or outside for easy adjustment to wide range of beams
7.To be used with hook suspended hoist
8.Suspension plate for easy attachment is standard
9.Bearings prepacked with lifetime lubricant
10.One-year warranty
Our Services
1.Client
We treasure and try to understand all the different needs of our clients and seek to forge a long term professional relationship with them. The satisfaction of each and every customer is our main goal and motivation in conducting our business.
2. People
We work as a team and treat each other with respect. Our solid, capable and knowledgeable team is valued as the greatest asset and an integral part of the business.
3. Product
Our products are of HIGH quality standards and always come with certificate of compliance by the manufacturers.
4. Performance
We aim to achieve high level of performance and satisfaction to both our client and people, which include delivering high quality services and treating people with integrity.
5. Free sample and OEM service
We can provide free samples to you and we also have OEM service, we can put your logo on the label and the information you need on the webbing too.
Plain Trolley
Adjustable Plain Trolley,Manual Plain Trolley,Plain Beam Trolley,Plain Push Trolley
Hebei Liston Lifting Rigging Manufacturing Co., Ltd. , http://www.liftingriggingfactory.com