Anti-leakage pump

Prevent leakage pump market prospects It is true that no leakage pump manufacturing costs more expensive than conventional pumps, but the use and maintenance costs than the average mechanical seal chemical pump is much lower. First of all, no leakage pump without mechanical seal and bearing box, the pump shaft is completely enclosed in the shielding sleeve (isolation sleeve), the variable seal is a static seal, effectively solve the problem of leakage and lubrication; Second, no leakage pump to cancel the coupling, Harden the connection as a soft connection, effectively solve the vibration and noise problems; In addition, no leakage pump wearing parts significantly reduced (only the bearing or the mouth ring), the accident is also relatively reduced (only the inner and outer rotor); the last , No leakage pump to extend the life of the operation, maintenance frequency and time greatly reduced, and significantly reduce the labor intensity overhaul. According to the statistics of ABS device from 2000 to 2001, the damage rate of conventional pump is 6 to 8 times that of non-leak pump, and the cost of replacement of consumable parts by mechanical seal chemical pump is 3 to 5 times of that of similar pump without leakage. According to the cumulative total cost calculation, roughly 4 ~ 5 years the number of both the same. The above is only from the cost point of view, and mechanical seal chemical pump leakage of materials tend to be expensive, caused by environmental pollution, safety accidents and other issues more.
Therefore, although a one-time investment without leakage pump larger, but no leakage of pollution, material conservation, maintenance and management of low cost, high overall economic efficiency, good social benefits. With economic development, social progress, state requirements for enterprises in technology, environmental protection and other fields are getting higher and higher, and vigorously promote the technology of leak-free pump technology has a good prospect.

This entry was posted in on